Manfrotto Mono Amp PS1150M Manuel d'utilisateur télécharger pdf

AMP

POWER

+12V

REM GND

1. Disconnect the negative (-) battery terminal.

NOTE: Check your vehicle's owner's manual before disconnecting the battery.

Disconnecting the battery in some vehicles may require an anti-theft code when

reconnecting for stereo operation. Some vehicles may run rough after reconnecting

the battery and require service to have the on-board computer reset. Check with

your local dealer if you are uncertain.

2. Run suitable AWG wire to where the amplifier will be mounted (run 1 foot extra than

you think you will need). Use rubber grommets where wires will pass through the

firewall or other areas of the vehicle. Make certain a fuse holder is placed within 18

inches of the vehicle battery – this is mandatory. Do not place a fuse in the fuse

holder at the battery at this time.

3. Mount the amplifier on a flat surface. Since a flat surface in a modern vehicle is often

difficult to find, an alternative is to cut a piece of 1/2 inch wood slightly larger than

the amplifier mounting area (covered with automotive type carpeting). Mount the

piece of wood, and then mount the amplifier to the carpeted wooden mount.

4. Ground the amplifier using the same AWG wire size used for the power cable. Make

sure the ground location is a clean, unpainted metal surface.

5. Run the RCA and Remote turn-on lead to the amplifier from the head unit.

6. Run speaker wires (16 AWG or larger) from your speakers to the amplifier.

7. Place a suitable size fuse in the fuse holder at the battery.

8. Ensure that the input level control is set to "MIN".

9. Turn on the head unit and make appropriate amplifier adjustments.

PS1150M Mono Amp Quick Start Guide

Fuse Block or Fuse Holder

Minimum Wire Size:

+12V - 10 AWG

Ground - 10 AWG

(

)

BATTERY

( )

Remote /

Power Antenna

Turn-on Wire

RCA Cable

CAR STEREO /

SOURCE UNIT

SPEAKERS

( )

(

)

(

)

LOW INPUT

NOTE: An optional wiring kit is required. See

your local Circuit City store or installation shop.

CHASSIS GROUND

Need help?

For technical assistance, call

the Jensen customer

support line at 1-800-323-4815.

WATTS

150

MONOMONO

RCA Cable 1

Résumé du contenu

Page 1 - RCA Cable

AMPPOWER+12VREM GND1. Disconnect the negative (-) battery terminal. NOTE: Check your vehicle's owner's manual before disconnecting the batt

Commentaires sur ces manuels

Pas de commentaire

Manfrotto Mono Amp PS1150M Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Récepteurs et amplificateurs Manfrotto Mono Amp PS1150M. Manfrotto Mono Amp PS1150M User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels